During the safety inspection of floor-standing scaffolding, it is necessary to first inspect according to the inspection points of the construction plan to check whether the height of the scaffolding exceeds the specification, whether there is no design calculation sheet and unapproved construction, and whether the staff follows the construction plan guidance Perform accurate construction.
Secondly, during the inspection of the pole foundation of the floor-standing scaffold, check whether the pole foundation is flat and solid every 10 meters of extension and whether the spacing of the pole, large crossbar, and small crossbar exceeds the specified requirements every 10 meters of extension, and It meets the requirements of the design plan. Besides, it is necessary to check whether there are bases, skids, and sweeping poles at the bottom of each 10 extended meters of vertical poles and whether there are corresponding drainage facilities; whether the scissor supports are installed by the specified requirements, and whether the angle of the scissor supports meets the requirements Claim.
Finally, in the safety inspection of the scaffolding and the protective fence, it is also necessary to check whether the scaffolding board is fully covered, whether the material of the scaffolding board meets the standard requirements, and whether there is a probe board. After the inspection, it is necessary to measure whether the construction layer is set to 1.2 meters. Are there high protective railings and toe boards? Observe whether the scaffolding is equipped with a dense mesh safety net and whether the nets are tight.
After the inspection is completed, it is necessary to clarify the scaffolding and go through the acceptance procedures and quantify the above-mentioned inspection standards and categories.
Post time: Sep-29-2020